|
|
"LazerMask™
does not contain PVC
which has been proven to destroy the laser’s
hardware."
- Brian Hemen, Epilog, Inc.
"GREAT
to use on
plotted substrates."
-
Ken, Academy Trophies
"WONDERFUL for
detail work!"
-
Will, Eagle Creek
-
Easy as 1, 2 ,3!
Apply, Laser, Sandcarve
-
Faster
Burn
- when
compared to vinyls
-
No
PVC or Gases
-
to destroy
laser hardware
-
Fantastic Detail
-
Deeper Etch
-
Faster Clean Up
- peels off
effortlessly unlike aggressive vinyls or tapes
-
Endorsed by leading Laser
Manufactures
"... goes on easy
and stays on.
I can go as deep as I want with
no blast
through."
-
Matt, Bainbridge Engraving
"Very easy to remove, nice
results."
- Gary, Northwest Trophy
"LazerMask™
has significantly
made our sandblast operations
simpler and easier
to
work with."
- Neil,
Winning Edge, Inc.
Download the
LazerMask™:
Order Form (PDF
22k)
Sell
Sheet (PDF
770k)
Application Profile
(PDF
480k)
|
Application
Profile
LazerMask™ Sandcarving Film
| Description/Application:
LazerMask™ is a
non-PVC sandcarving film that won’t corrode
your laser’s hardware. With LazerMask™ you can
utilize the accuracy and precision of a laser engraver to
reproduce images into glass, crystal, and
stone while retaining the beauty and depth of traditional sandcarving.
Durability:
LazerMask™
has blast resilient properties equal to Rayzist’s SR2000™ photo resist
film.
Productivity:
LazerMask™ eliminates the steps of a traditional photomask. Just
apply, laser, and sandcarve; a major benefit
for smaller runs. Blast high resolution designs quickly and easily
saving time in application, burn time and
clean up.
Available: 4",
6", 8" & 10" wide x 200’ rolls.
Requirements:
To use LazerMask™ sandcarving film, you need a laser engraver and a
sandcarving
system similar to our
2034
Automatic Recycling System.
Shelf Life:
Non-Applicable. Store at room temperature. No special handling
required.
Material Chosen and Why:
LazerMask™ sandcarving film is
a non-PVC sandcarving film offering a
fast burn, great detail, durability, with a fast and easy clean
up... without the need for sticky, hard to use
vinyls or tapes.
|
Instructions for Use
Apply - Laser -
Carve
|
1. Apply LazerMask™ to the
flat surface of the item with a plastic burnisher (squeegee)
to remove the clear carrier sheet.
2. Laser the image
(typically 80% power, 100% speed. Actual settings determined by laser
wattage and detail/resolution of design)
onto LazerMask™.
3. Sandcarve the item.
4. Paint fill (if desired) while the mask is still on.
If using Rayzist Paint Pens, remove mask and
use as instructed.
|
© Copyright 1997-2008 Rayzist Photomask, Inc. All rights reserved.
|