There are 2 messages in this issue.

Topics in today's digest:

      1. New to list :)
           From: Andrea Sloan Goodsaid <andrea@xxxxxxx.xxxx
      2. Re: New to list :)
           From: Donna/REgina <starcreations@xxxxxxxx.xxx.xxxx


_______________________________________________________________________________
_______________________________________________________________________________

Message: 1
   Date: Mon, 19 Jul 1999 12:55:00 -0600
   From: Andrea Sloan Goodsaid <andrea@xxxxxxx.xxxx
Subject: New to list :)


Hi all,

I was so glad to happen on this list! Been half-lurking since near the
start... much of what's been discussed so far has been way beyond anything
I can add to since we're just new to this medium last Fall and aren't quite
'carving' yet. 

So far, we're using rubber stencil and are at a point where we need to buy
by the roll. Anyone have a good source for that? We're in Montana, so this
end of the country would probably make sense s/h wise. Does everyone here
use photo-resist?

Also, along that line, does anyone have a model preference for plotters
that could handle the rubber resist (up to 33?mil) ... we're looking at
Anagraph's AE75-SB, but have had some question over it being a friction
feed rather than punched. Any opinions?

Hope to be able to add something along the way here, but for
now...questions, questions questions....

Thanks,
Andrea


_______________________________________________________________________________
_______________________________________________________________________________

Message: 2
   Date: Mon, 19 Jul 1999 13:47:25 -0600
   From: Donna/REgina <starcreations@xxxxxxxx.xxx.xxxx
Subject: Re: New to list :)

Andrea Sloan Goodsaid wrote:
> 
> From: Andrea Sloan Goodsaid <andrea@sageart.com>
> 
> Hi all,
> 
> I was so glad to happen on this list! Been half-lurking since near the
> start... much of what's been discussed so far has been way beyond anything
> I can add to since we're just new to this medium last Fall and aren't quite
> 'carving' yet.
> 
> So far, we're using rubber stencil and are at a point where we need to buy
> by the roll. Anyone have a good source for that? We're in Montana, so this
> end of the country would probably make sense s/h wise. Does everyone here
> use photo-resist?
> 
> Also, along that line, does anyone have a model preference for plotters
> that could handle the rubber resist (up to 33?mil) ... we're looking at
> Anagraph's AE75-SB, but have had some question over it being a friction
> feed rather than punched. Any opinions?
> 
> Hope to be able to add something along the way here, but for
> now...questions, questions questions....
> 
> Thanks,
> Andrea
> 
> --------------------------- ONElist Sponsor ----------------------------
> 
> Your anytime, anywhere sports store. Fogdog Sports.
> <a href=" http://clickme.onelist.com/ad/fogdog1 ">Click Here</a>
> 
> ------------------------------------------------------------------------
Hi Andrea, wish I could answer your questions....call the manufactors of
resist and ask them questions...also they might know where you can
obtain a plotter, or call sign suppliers....
Donna
starcreations@att.net