|
Required
Products: 1. Clean the Glass. Insure both pieces (Base and Item) are clean and free of dust or residue. This can be done with a soft cloth and glass cleaner. Pay particular attention to the areas to be bonded. Do not handle the areas where the adhesive will be applied.
2.
Apply Adhesive.
3. Spread Adhesive. using a fine bristle brush or a soft cloth, spread the glue evenly across the piece. 4. Place the items together. Center the show piece evenly on the base.
5.
Expose the Bond.
When centered, expose the items to a UV light source. The Letralite
Exposure Unit is perfect for bonding UV adhesive: simply remove the
cylinder and turn the unit on its side. Place the items directly in
front of the unit no more than 4 inches away from the light source.
The items will cure with-in 90
6. Check the Bond. Be sure the bond is firm. It should be completely free of any movement. 7. Remove Excess Glue. Clean up excess glue with an organic solvent.
FOR SAFE HANDLING INFORMATION ON THESE PRODUCTS, CONSULT THE MATERIAL SAFETY DATA SHEET OR VISIT: www.loctite.com Material Safety Data Sheets:
Technical Data Sheet (PDF):
|
Apply UV adhesive. Do this by placing one small dot per half
inch to one surface only, usually the show piece. Excessive glue is not
needed and will not clean up properly.
seconds.
Be sure to make final adjustments prior to exposing to the light source.